Polyimide Tape 10 cm x 33m

This Polimide Tape can be applied to our PCB Heatbed and other surfaces.

 

When hot, the plastics will stick to it. Temperatures needed:

- PLA: 60-70°C

- ABS: ...

RepRap Arduino MEGA Pololu Shield (RAMPS) 1.4 Kit, SMD pre-soldered

The RAMPS board plugs into an Arduino MEGA and holds four Pololu stepper motor drivers and the other electronics necessary to run a 3d printer.

It supports five stepper axes (X,Y,Z, ...

Opto Endstop RRS-OE Set x3

This set contains every component needed to build 3 Opto Endstop boards. For a reprap machine you will need at least 3 endstops (1 set). 6 are recommended (2 sets). The Opto Endstops can also be ...

Temperature Sensor PCB only

This board is a circuit that turns a thermistor into a temperature input readable by a microcontroller.
It contains the PCB only, you will need to source all the necessary components ...

Temperature Sensor Kit

This set contains every component needed to build a thermistor based temperature sensor. Content: 1x PCB, all components to build it, 1x 100k NTC Thermistor 4085. A soldering iron and solder is ...

Pololu USB AVR Programmer

General AVR ISP Programmer The Pololu USB AVR Programmer is an extremely compact, low-cost in-system programmer (ISP) for Atmel’s AVR mirocontrollers, which makes this device an attractive ...

PCB Heatbed Mk1

This is a very special PCB which provides a heated surface for Reprap or Reprap-like machines. A heatbed allows almost warp-free and raftless printing of ABS plastic, over its full print ...

Microswitch-Set (3 pcs)

Mechanical Endstops, 3 pcs.

Lever: Sim. Roller (as illustrated) or standard (straight) lever, depending on part availability.

A4988 Stepper Motor Driver Carrier

This tiny board uses the Allegro A4988 microstepping driver. It can be configured down to 1/16 step, which makes the stepper movement really smooth and silent.

While the chip is rated ...